Minority Views
[To accompany H.R. 3174] The Committee on Small Business, to whom was referred the bill (H.R. 3174) to increase loan limits for loans made to small manufacturers, and for other purposes, having considered the same, reports favorably thereon with an amendment and recommends that the bill as amended do pass. CONTENTS Page I. Purpose and Bill Summary........................................2 II. Need for Legislation............................................2 III. Hearings........................................................3 IV. Committee Consideration.........................................3 V. Committee Votes.................................................3 VI. Section-by-Section of H.R. 3174.................................3 VII. Congressional Budget Office Cost Estimate.......................4 VIII. New Budget Authority, Entitlement Authority, and Tax Expenditure4 IX. Oversight Findings & Recommendations............................4 X. Performance Goals and Objectives................................4 XI. Statement of Duplication of Federal Programs....................4 XII. Congressional Earmarks, Limited Tax Benefits, and Limited Tariff Benefits........................................................5 XIII. Federal Mandates Statement......................................5 XIV. Federal Advisory Committee Statement............................5 XV. Applicability to Legislative Branch.............................5 XVI. Statement of Constitutional Authority...........................5 XVII. Changes in Existing Law Made by the Bill, as Reported...........5 XVIII.Minority Views................................................114 The amendment is as follows: Strike all after the enacting clause and insert the following: SECTION 1. SHORT TITLE. This Act may be cited as the ``Made in America Manufacturing Finance Act''. SEC. 2. DEFINITIONS. Section 3 of the Small Business Act (15 U.S.C. 632) is amended by adding at the end the following: ``(gg) Small Manufacturer.--The term `small manufacturer' means a small business concern-- ``(1) the primary business of which is classified in sector 31, 32, or 33 of the North American Industrial Classification System; and ``(2) all of the production facilities of which are located in the United States.''. SEC. 3. SMALL BUSINESS ACT LOAN LIMITS FOR SMALL MANUFACTURERS. Section 7(a) of the Small Business Act (15 U.S.C. 636(a)) is amended-- (1) in paragraph (3)-- (A) in subparagraph (A)-- (i) by inserting ``except as provided in subparagraph (B),'' before ``if the total''; (ii) by striking ``would exceed $3,750,000'' and inserting the following: ``would exceed-- ``(i) $3,750,000''; (iii) in clause (i), as so designated, by striking ``, except as provided in subparagraph (B);'' and inserting ``; or''; and (iv) by adding at the end the following: ``(ii) in the case of a borrower that is a small manufacturer, $7,500,000 (or if the gross loan amount would exceed $10,000,000);''; and (B) in subparagraph (B)-- (i) by striking ``would exceed $4,500,000'' and inserting the following: ``would exceed-- ``(i) $4,500,000''; (ii) in clause (i), as so designated, by striking ``section 7(a)(14) for export purposes; and'' and inserting ``paragraph (14) for export purposes; or''; and (iii) by adding at the end the following: ``(ii) in the case of a borrower that is a small manufacturer, $9,000,000 (or if the gross loan amount would exceed $10,000,000), of which not more than $8,000,000 may be used for working capital, supplies, or financings under paragraph (14) for export purposes; and''; and (2) in paragraph (14)(B)(i), by striking ``than $5,000,000.'' and inserting the following: ``than-- ``(I) except as provided in subclause (II), $5,000,000; or ``(II) in the case of a loan made to a small manufacturer, $10,000,000.''. SEC. 4. SMALL BUSINESS INVESTMENT ACT OF 1958 LOAN LIMITS FOR SMALL MANUFACTURERS. Section 502(2)(A)(iii) of the Small Business Investment Act of 1958 (15 U.S.C. 696(2)(A)(iii)) is amended by striking ``$5,500,000'' and inserting ``$10,000,000''. I. Purpose and Bill Summary On May 1, 2025, Chairman Roger Williams, introduced H.R. 3174, the Made in America Manufacturing Finance Act of 2025. H.R. 3174 increases the loan limit for small American manufacturers under the U.S. Small Business Administration's (SBA) 7(a) and 504 lending programs from $5 million and $5.5 million, respectively, to $10 million. II. Need for Legislation The SBA provides government-backed guarantees on private sector loans to small businesses through two major lending programs, the 7(a) and 504 loan programs. Both programs are funded through the collection of lender fees and operate at zero-subsidy, i.e. zero cost to taxpayers. Manufacturing is an inherently capital-intensive industry, which creates significant barriers to financing for small manufacturers. The Made in America Manufacturing Finance Act of 2025 will empower the SBA to meet the capital needs of domestic manufacturers and supercharge the return of Made in America. For far too long, American manufacturers have been undercut by unfair trade practices, burdensome regulations, and over taxation. President Trump has made it a priority to revitalize the U.S. manufacturing sector and bring jobs back that were carelessly outsourced, often to foreign adversaries. President Trump recently secured nearly $2 trillion in pledged investment in domestic manufacturing.\1\ Thanks to pro-growth policies and increased market demand, SBA loan approvals for small manufacturers increased by 80 percent in the first 100 days of the Trump Administration.\2\ --------------------------------------------------------------------------- \1\The White House, President Trump Is Putting American Workers First and Bringing Back American Manufacturing (Mar. 31, 2025). \2\News Release, U.S. Small Bus. Admin., Small Business Administration Celebrates First 100 Days Accomplishments (Apr. 29, 2025). --------------------------------------------------------------------------- H.R. 3174 would support the Trump Administration's efforts to revitalize American manufacturing. Boosting domestic manufacturing will not only create jobs and provide economic stability but also support a strong manufacturing base for U.S. national defense priorities.\3\ --------------------------------------------------------------------------- \3\Connected World Manufacturing and National Security, https:// connectedworld.com/ manufacturing-and-national-security (last visited Jul. 14, 2025). --------------------------------------------------------------------------- III. Hearings On June 4, 2025, the Committee on Small Business held a hearing examining matters related to H.R. 3174 entitled ``Budgeting for Growth: Testimony from SBA Administrator Kelly Loeffler.'' IV. Committee Consideration The Committee on Small Business met in open session, with a quorum being present, on July 22, 2025, and ordered H.R 3174, as amended, to be reported favorably to the House of Representatives by voice vote. During the markup the Committee adopted an amendment in the nature of a substitute offered by Chairman Williams by voice vote. V. Committee Votes Clause 3(b) of rule XIII of the Rules of the House of Representatives requires the Committee to list the recorded votes on the motion to report legislation and amendments thereto. The Committee voted to favorably report H.R. 3174, as amended, to the House of Representatives at 10:43 AM by voice vote. VI. Section-by-Section of H.R. 3174 Section 1--Short title This bill may be cited as the ``Made in America Manufacturing Finance Act of 2025.'' Section 2--Definitions This section defines key terms mentioned throughout the bill. Section 3--Small Business Act loan limits for small manufacturers This amends section 7(a) of the Small Business Act to raise the loan limit for small business manufacturers under the SBA's 7(a) lending program from $5 million to $10 million. Additionally, this section codifies the guaranteed loan amounts, aligning them with the SBA's existing guaranteed rates: 75 percent for general 7(a) loans and 90 percent for international trade loans, or $7.5 million and $9 million, respectively. Section 4--Small Business Investment Act of 1958 loan limits for small manufacturers This section amends the Small Business Investment Act to raise the loan limit for small business manufacturers under the SBA's 504 loan program from $5.5 million to $10 million. VII. Congressional Budget Office Cost Estimate Pursuant to 3(c)(3) of rule XIII of the Rules of the House of Representatives, the Committee adopts as its own the cost estimate prepared by the Director of the Congressional Budget Office pursuant to section 402 of the Congressional Budget Act of 1974. At the time this report was filed, the Committee has requested but not received a cost estimate from the Director of the Congressional Budget Office. VIII. New Budget Authority, Entitlement Authority, and Tax Expenditures Pursuant to clause 3(c)(2) of rule XIII of the Rules of the House of Representatives and section 308(a)(I) of the Congressional Budget Act of 1974, the Committee provides the following opinion and estimate with respect to new budget authority, entitlement authority, and tax expenditures. While the Committee has not received an estimate of new budget authority contained in the cost estimate prepared by the Director of the Congressional Budget Office pursuant to section 402 of the Congressional Budget Act of 1974, the Committee does not believe that there will be any new or increased costs attributable to this legislation. IX. Oversight Findings & Recommendations In accordance with clause 2(b)(1) of rule X and clause 3(c)(1) of rule XIII of the Rules of the House of Representatives, the oversight findings and recommendations of the Committee on Small Business with respect to the subject matter contained in H.R. 3174 are incorporated into the descriptive portions of this report. X. Performance Goals and Objectives With respect to the requirements of clause 3(c)(4) of rule XIII of the Rules of the House of Representatives, the goal of H.R. 3174 is to meet the capital needs of small domestic manufacturers. XI. Statement of Duplication of Federal Programs Pursuant to clause 3(c)(5) of rule XIII of the Rules of the House of Representatives, no provision of H.R. 3174 is known to be duplicative of another Federal program, including any program that was included in a report to Congress pursuant to section 21 of Public Law 111-139 or the most recent Catalog of Federal Domestic Assistance. XII. Congressional Earmarks, Limited Tax Benefits, and Limited Tariff Benefits With respect to clause 9 of rule XXI of the Rules of the House of Representatives, the Committee finds that the bill does not contain any congressional earmarks, limited tax benefits, or limited tariff benefits as defined in clause 9(e), 9(f), or 9(g) of rule XXI of the Rules of the House of Representatives. XIII. Federal Mandates Statement The Committee adopts as its own the estimate of Federal mandates prepared by the Director of the Congressional Budget Office pursuant to section 423 of the Unfunded Mandates Reform Act. XIV. Federal Advisory Committee Statement No advisory committees within the meaning of section 5(b) of the Federal Advisory Committee Act were created by this legislation. XV. Applicability to Legislative Branch The Committee finds that the legislation does not relate to the terms and conditions of employment or access to public services or accommodations within the meaning of section 102(b)(3) of the Congressional Accountability Act. XVI. Statement of Constitutional Authority Pursuant to clause 7 of rule XII of the Rules of the House, the Committee finds that the authority for this legislation in Art. I, Sec. 8, cl. 1 of the Constitution of the United States. XVII. Changes in Existing Law Made by the Bill, as Reported In compliance with clause 3(e) of rule XIII of the Rules of the House of Representatives, changes in existing law made by the bill, as reported, are shown as follows (existing law proposed to be omitted is enclosed in black brackets, new matter is printed in italics, and existing law in which no change is proposed is shown in roman): Changes in Existing Law Made by the Bill, as Reported In compliance with clause 3(e) of rule XIII of the Rules of the House of Representatives, changes in existing law made by the bill, as reported, are shown as follows (existing law proposed to be omitted is enclosed in black brackets, new matter is printed in italics, and existing law in which no change is proposed is shown in roman): SMALL BUSINESS ACT * * * * * * * SEC. 3. DEFINITIONS. (a) Small Business Concerns.-- (1) In general.--For the purposes of this Act, a small-business concern, including but not limited to enterprises that are engaged in the business of production of food and fiber, ranching and raising of livestock, aquaculture, and all other farming and agricultural related industries, shall be deemed to be one which is independently owned and operated and which is not dominant in its field of operation. (2) Establishment of size standards.-- (A) In general.--In addition to the criteria specified in paragraph (1) and subject to the requirements specified under subparagraph (C), the Administrator may specify detailed definitions or standards by which a business concern may be determined to be a small business concern for the purposes of this Act or any other Act. (B) Additional criteria.--The standards described in paragraph (1) may utilize number of employees, dollar volume of business, net worth, net income, a combination thereof, or other appropriate factors. (C) Requirements.--Unless specifically authorized by statute, no Federal department or agency (including the Administration when acting pursuant to subparagraph (A)) may prescribe a size standard for categorizing a business concern as a small business concern, unless such proposed size standard-- (i) is proposed after an opportunity for public notice and comment; (ii) provides for determining-- (I) the size of a manufacturing concern as measured by the manufacturing concern's average employment based upon employment during each of the manufacturing concern's pay periods for the preceding 24 months; (II) the size of a business concern providing services on the basis of the annual average gross receipts of the business concern over a period of not less than 5 years; (III) the size of other business concerns on the basis of data over a period of not less than 3 years; or (IV) other appropriate factors; and (iii) is approved by the Administrator. (3) Variation by industry and consideration of other factors.--When establishing or approving any size standard pursuant to paragraph (2), the Administrator shall ensure that the size standard varies from industry to industry to the extent necessary to reflect the differing characteristics of the various industries and consider other factors deemed to be relevant by the Administrator. (4) Exclusion of certain security expenses from consideration for purpose of small business size standards.-- (A) Determination required.--Not later than 30 days after the date of enactment of this paragraph, the Administrator shall review the application of size standards established pursuant to paragraph (2) to small business concerns that are performing contracts in qualified areas and determine whether it would be fair and appropriate to exclude from consideration in the average annual gross receipts of such small business concerns any payments made to such small business concerns by Federal agencies to reimburse such small business concerns for the cost of subcontracts entered for the sole purpose of providing security services in a qualified area. (B) Action required.--Not later than 60 days after the date of enactment of this paragraph, the Administrator shall either-- (i) initiate an adjustment to the size standards, as described in subparagraph (A), if the Administrator determines that such an adjustment would be fair and appropriate; or (ii) provide a report to the Committee on Small Business and